English
⋅
Eltropol 300
31
85
95
5 B
A
-en
/1
1
en
Securing objects
One or two objects may be secured and polished
simultaneously.
1.
Securing the polishing object to the object
holder: use the retentions to hang it on the
hook, or secure the base with the crocodile
clip.
2.
Insert the object holder into the unit and tighten
the screws. Please ensure that:
• the object is fully immersed in Wirolyt. (The
springs of the crocodile clip are not perma-
nently electrolyte-resistant and should
therefore not be immersed.)
• sufficient space remains at the bottom of the
polishing bath for the magnetic stirrer.
• the base surfaces of the polishing objects
must be aligned
parallel
to the longitudinal
sides of the bath. Exposed clasp tips must
never point directly towards the cathode, as
this would cause too much material to be
removed from them!
• object and cathode must not touch each oth-
er (error message E 10).
WARNING
• Avoid contact with skin and eyes!
Risk of blinding!
• Wear safety glasses and safety
gloves!
Never add water!
NOTE
• Polishing only works on clean, oxide-free met-
al objects. If necessary, blast objects prior to
polishing.
• Only use the electrolyte-resistant object holder
included with the unit! Copper object holders
wear down during polishing and produce sed-
iment, which impedes the magnetic stirring
process.
• To protect against severe wear during gloss-
ing, the tips of the clamps should be covered
with masking lacquer.
