English
⋅
Gelovit 200
29
8
5
9
8
0
B
A
-e
n
/0
5
3
3
4
.0
0
1
7
1
…
en
Installation
Check set temperatures
1.
Switch on main power switch on right side of
unit: the display indicates the actual tempera-
ture in the duplicating material container.
2.
Keep button „T1“ depressed until the acoustic
signal sounds twice: the display indicates the
set temperature desired for approx. 4 seconds.
3.
If necessary, change the temperature with the
buttons "+" and "-".
4.
Check/change T2 and T3 in the same way.
Notes
•
The factory-set temperatures are recommended for BEGO duplicating materials Castogel
®
and
Wirodouble
®
:
•
The temperatures for
Wirogel M
have to be changed to: T1 = 96 °C, T2 and T3 = 54 °C (Wirogel M
cannot be processed at reduced temperature)!
•
The factory setting of the temperature display is in °C. To change over to °F, call Customer Service.
WARNING
Property damage!
•
The unit may only be installed on an
adequately stable surface.
•
The unit may only be used in an
enclosed space.
WARNING
Electrical hazard!
•
Prior to the electrical connection
check whether the specifications on
the rating plate correspond to the
power supply network. In the case
of uncertainty, consult an electri-
cian.
•
The machine is subject to the provi-
sions of class of protection I and
may only be connected to properly
grounded power sources.
NOTE
The new temperature is saved approx. 4 seconds
after the last input.
T1
melting temperature = 93 °C,
T2
operating temperature = 42 °C,
(T2 cannot be set lower than T3.)
T3
reduced operating temperature = 39 °C.
(T3 cannot be set higher than T2.)
