30
8
5
9
8
0
B
A
-e
n
/0
5
3
3
4
.0
0
1
7
1
…
English
⋅
Gelovit 200
en
Filling
1.
Open the cover.
2.
Fill with fist-size pieces of duplicating material:
minimum of 3 kg, maximum of 6 kg.
3.
Close the cover and turn so that it is locked.
The heating system and mixer only work when
the cover is locked.
WARNING
Burn hazard from hot parts!
•
During the melting process the
housing and cover become hot! Let
the unit cool down or use safety
gloves before touching the cover.
•
Be careful when reaching into the
container. Pull out the mains plug
before reaching in!
•
The agitator has sharp edges!
•
The container may be very hot!
NOTE
•
Used duplicating material can be re-utilised, but
must first be melted. Clean used duplicating
material carefully with water. Do not put used
duplicating material in the container until imme-
diately
before the next melting operation
.
•
Do not forget: After filling the unit with fresh
duplicating material, you must reset the counter
for the melting cycles to 0 (press the "+" und "-
" buttons simultaneously and keep them
depressed until the acoustic signal sounds
twice).
