English
⋅
Miditherm MP
45
8
5
8
1
7
B
A
-e
n
/1
2
3
0
6
.0
1
2
6
9
…/
3
0
7
.0
0
8
0
4
…
en
Acoustic signal / cut-out temperature of extraction system
At the end of a program an acoustic signal sounds.
If desired, the signal can be switched off perma-
nently.
The Regulus extraction system can be connected to
the rear socket. You can set up to what furnace
temperature the suction extraction unit is supplied
with power .
1.
When switching on unit, keep
depressed:
display shows "P1" (after approx. 3 seconds)
and an acoustic signal sounds.
2.
Press
3 times
: display shows "P4".
3.
Press
:
1 = signal on
0 = signal off
4.
Press
: display shows "P5.
5.
Press
to set the cut-out temperature of
the Regulus extraction system. The factory
setting (600°C) is adequate for customary
investment materials that are heated up slowly.
For shock heat investment materials, the Reg-
ulus furnace extraction system must be set to
continuous operation (
→
page 39).
6.
Press
twice:
display shows the current furnace temperature
(after approx. 7 seconds).
NOTE
•
Setting from P1 to P3 (weekday , time):
→
page 44.
•
P6 has no function.
