English
⋅
Miditherm MP
31
8
5
8
1
7
B
A
-e
n
/1
2
3
0
6
.0
1
2
6
9
…/
3
0
7
.0
0
8
0
4
…
en
Safety Instructions
Miditherm is designed exclusively for wax removal
from and preheating of dental objects, such as
duplicate models and casting moulds made of
commercially available investment materials. Any
other use is considered to be improper. We shall not
be liable for any damage resulting from improper
use.
The safety instructions must be followed in order to
prevent personal injury and damage to the machine.
We shall not be liable for damage due to failure to
comply with the safety instructions.
General Safety Instructions
Place of use
The unit has been designed solely for use in dental
laboratories and comparable establishments for
research, commercial and training purposes.
The unit may only be installed on an adequately
stable surface.
The unit must only be used in dry rooms.
Operator and operating personnel
The unit must only be operated by dental profes-
sionals, or they must provide supervision if
trainees or other persons operate unit.
Wear the protective clothing prescribed for use in
dental laboratories and observe the rules of
conduct.
The unit may only be operated by staff members
who are familiar with and follow the instructions of
this operating manual.
The operating manual must be easily accessible
when the machine is operated. Observe the national
accident prevention regulations in addition to this
operating manual.
Handling the machine
Prior to the electrical connection check whether the
specifications on the rating plate correspond to the
power supply network. In the case of uncertainty,
consult an electrician.
The unit is categorised under protection class 1 and
may only be connected to properly earthed power
sources (earth contact sockets).
Modifications to the device and the mains unit must
not be carried out.
Always keep signs and stickers such that they are
easy to read. They must not be removed.
Check the machine and leads for damage regularly.
The machine must not be operated if it has any
defects that may result in risks for the employees or
third persons.
Protect the leads against heat, oil and sharp edges.
The leads must not be used to carry the machine or
to pull out the mains plug.
Repair work
Repairs may be carried out solely by BEGO
customer service or by persons authorised by
BEGO customer service.
Metallic housings
must be grounded properly so
as to prevent them from carrying current. Otherwise
they are extremely dangerous because the
housings may be live due to damage to the
machine! Since a check to ensure a de-energized
state is mandatory after every intervention in the
machine (Germany: check in accordance with DIN
VDE 0701-1), only qualified electricians may open
the machine!
Only BEGO replacement and wearing parts may be
used.
Care and maintenance
Switch off the machine and pull out the mains plug
before performing any care, cleaning or mainte-
nance work.
Only use dry or slightly moist cloths for cleaning. Do
not spray the machine with water or immerse it in
water.
