English VARSEO S
17
86
08
7 B
A
-en
/0
2
en
Setting up a network connection via LAN cable
Your device requires a network connection with
myBEGO in order to acquire the desired indications.
1.
Plug the LAN cable into the Ethernet socket on
the back of the VARSEO S.
2.
Connect the other end of the LAN cable with
the "LAN" socket of your router / network con-
nector.
3.
Switch the VARSEO S on with the power
switch located on the right side of the device.
The BEGO software will be loaded.
4.
Select the language.
5.
Press the LAN button.
6.
Check under "Settings" > "User Menu" > "Net-
work" if the entries are correct. LAN and
DHCP must be activated!
Button 1: Selection "LAN" or "WLAN"
Button 2: Selection "DHCP" or "Static"
7.
If DHCP is not supported by your network, use
the expert mode "Static". Please consult an IT
expert to that end.
1
2
NOTE
The VARSEO S device must be switched off.
NOTE
Only connect the VARSEO S via LAN or WLAN;
otherwise, the host name cannot be clearly
allocated! Contact an IT expert, if needed.
NOTE
If your network supports DHCP, the VARSEO S
will automatically connect with your network.
The device will display an error message if no
connection could be established between the
network and the device.
Summary of Contents for VARSEO S Basic
