19
BL3300 SERIES MANUAL 01/28/2013
SECTION 4
MAINTENANCE AND ADJUSTMENTS
!
WARNING
This equipment involves the use of voltages and currents that can be hazardous.
Only qualified personnel should be allowed to operate or service it. The top
cover(s) must always be in place during operation.
Before performing any adjustments where access to the inside of the equipment is
required, be sure to turn off the unit and allow five minutes for the DC power supply
capacitors to discharge.
4.1 MAINTENANCE
WARNING:
FAILURE TO MAINTAIN OR OPERATE THE UNIT PROPERLY WILL VOID THE WARRANTY.
AMONG THE ABUSES THAT ARE INCLUDED (BUT NOT LIMITED TO) ARE:
NOT MAINTAINING THE CLEANLINESS OF THE FILTERS (VACUUMING), OPERATING
OUTSIDE THE ALLOWABLE ENVIRONMENT, AND PHYSICALLY DAMAGING THE UNIT.
The decision on whether a units warranty is voided will be exclusively reserved for Behlman.
4.2 ADJUSTMENTS
NOTE
All the potentiometers used in the procedures that follow are located on the control
chassis. Always use a non-metallic screwdriver when adjusting potentiometers.
4.2.1
TEST EQUIPMENT REQUIRED
TEST EQUIPMENT
MANUFACTURER/MODEL
Current Clamp
Fluke 80I-600 (or equivalent
current
transformer)
Digital Voltmeter (DVM)
Fluke 8062A (or equivalent)
Frequency Counter
HP 5314A (or equivalent)
Oscilloscope
Iwatsu SS-5571 (or equivalent)
Summary of Contents for BL3300 Series
