7B
REV. C
B-6
1.5
CATASTROPHIC ERRORS
A catastrophic failure is generated each time the AC Power Supply experiences a hardware
failure. Errors are cleared whenever the AC Power Supply transmits a response, except in
the
case of a short circuit fault which may only be cleared by cycling power to the AC Supply.
Catastrophic Error Messages
All begin with:
F/0/0ACS/0(DEV):
This message is followed by one explanatory message from the
following text:
OVERTEMP FAULT <cr><lf>
The heatsink temperature has exceeded its upper limit. The
OVERTEMP LED on the front panel will light.
CURRENT LIMIT FAULT <cr><lf>
SHORT CIRCUIT FAULT: AC SUPPLY<cr><lf>
An output loading fault has occured causing the supply to exceed
5/0/0% rated current output. The supply automatically shuts down
and opens its output relay. The OVERLOAD LATCH LED on the
front panel will light.
1.6
ADDRESS SELECTION
The GPIB Address for the BL Series Power Supplies is configured via the dipswitch located
on the rear panel. The dip switch represents the address in binary format. Valid GPIB
Address settings are from 0 to 30. Switch 1 is the LSB, switch 5 is the MSB. Each individual
switch bit is set ('1') when in the 'OFF' position and reset ('0') when in the 'ON' position.
ADDRESS SWITCH SETTING
Summary of Contents for BL3300 Series
