C-3
CIIL COMMANDS
EXPLANATION
-ALL SET, SRX,SRN
commands are part of the setup command above.
SET VOLT <value>
Sets output voltage to given value,in volts rms. The following values are
permitted:
0 < value < 135, or 270, dependent on range selected and type of unit.
If set volt (value) not received, then use SRN VOLT (value), or SRX VOLT
(value). If none of these 3 are sent then generate error message.
SET FREQ <value>
Optional. Sets frequency of output voltage to given value, in Hz. The following
values are permitted:
45 < value < 500. Default is 45 Hz only if SET FREQ,
SRN FREQ, or SRX FREQ are not received. Otherwise the values shall be
used in the order stated.
SRX VOLT <value>
Optional. Sets maximum limit for SET VOLT command. If SET VOLT
value is greater than SRX VOLT value in a command string, an error
message is generated and the setup command ignored. The following
values are permitted:
0 < value < 135, or 270, dependent on range selected and type of unit.
If a value for SRX VOLT is not specified, the required maximum value for
SET VOLT default to 135, or 270, dependant on range selected and type
of unit.
SRN VOLT <value>
Optional. Sets minimum value limit for SET VOLT command. If SET VOLT
value is less than SRN VOLT value in a command string, an error
message is generated and a setup command ignored. The following
values are permitted:
0 < value < 135, or 270, dependent on range selected and type of unit.
The SET VOLT default is 0 for the minimum value if a value is not
specified
for SRN VOLT.
SRX FREQ <value>
Optional. Sets maximum limit for SET FREQ command. If the SET FREQ
value in a command string is grater than the maximum limit, an error
message is generated and the setup command ignored. Legal values are:
45 < value < 500.
If a value for SRX FREQ is not specified, SRX FREQ defaults to 500.
SRN FREQ <value>
Optional. Assigns minimum value to SET FREQ command. If the SET FREQ
value in a command string is less than the minimum limit, an error message
is generated and the setup command ignored. Legal values are:
45 < value < 500.
If a value for SRN FREQ is not specified, SRN FREQ defaults to 45.
SET VLT0
Set LO voltage range.
SET VLT1
Set HI voltage range.
Summary of Contents for BL3300 Series
