P1351ser.wpd
5-3-3
4.0
APPLICATIONS ( Continued )
The analog remote control board may be re-configured to allow control of the output and range relays
of the power source via a set of “dry” contacts. This requires removal of the power supply cover and
inserting jumpers on the remote control board.
This should be performed by
qualified personnel only
!
The jumpers ( also known as shunts) may be obtained from Behlman or from any electronics distributor.
These are standard shunts used throughout the computer industry to set board configurations and are
for use on 0.1inch headers. The Behlman part number is 102-473-000.
The alternate configuration is illustrated below. Note the in15 Vdc is now tied to pins 5 and 7 of
the remote connector.
These connections should not be used !
(Figure 2) Alternative Configuration.
For further information on use of the analog remote control option contact the Behlman sales office.
