38
of digital recorders dont want you to hear this! If you really want to take your recording level to the limit (and
fully exploit digitals 96 dB dynamic range), youll have some calibrating to do. You could run a tone at 0 dB
from the mixer, and use that as your DAT or digital multitrack recorder reference. But your DAT or digital
multitrack recorder may still be 10 to 20 dB off its headroom limit. Probably a better way to work out just how
hard you can drive your recorder is to incrementally increase the record level until it well distorts, subtract, say
6 dB, and never ever exceed that level.
When recording to analog, the tape machines VU meters should show 3dB on BASS, but only
around -10 dB for HI HAT. Although analog distortion is more like compression at modest overload levels
(often desirable on bottom end), higher frequencies cause saturation even at modest levels (an unpleasant
crunchiness). Also, VU meters tend to progressively under-read above 1 kHz, due to their sluggish response
time.
13.2.4Auditioning a mix
In order to be heard other than when PFL/SOLO-ed, channels must be routed to the main mix bus. This can
be either from the channel routing matrix directly, via one of the subgroups, or from the MIX-B bus (S48
DOWN).
Channels going to tape are usually monitored via the tape return channel, whether A or B. In this case the
main mix button of the channel going to tape should be UP, while that coming back should be DOWN (if on an
A-channel). Tape tracks returning on B-channels will always be heard so long as the MIX-B/MAIN MIX switch
(S48) is depressed.
Some to-tape channels will have no routing other than a direct out patch into the recorder, others may be
routed through subgroups. When a subgroup is sending to tape, the subgroup L/R assignment buttons (S37,
38) should be UP. I.e. that subgroup should not feed into the main mix bus directly.
13.2.5Mixer mapping
When laying out channels for recording or mixing, try to be sensible. Keep tom-toms together, etc. Work out
a scheme that suits you and stick to it, e.g. I always started with kick drum, snare, hi-hat, tom-toms (as the
audience sees them), cymbals (ditto), bass, guitars, keyboards, other instruments, vocals. From session to
session I knew what was where without hardly ever having to look at a tracksheet.
14. 8-TRACK MIDI SUITE/DANCE PRODUCTION STUDIO
8-track MIDI studio with sampler, 8-track recording system, one vocal microphone and an array of synthesizers
and FX. MIDI sequencer driven. A typical dance production suite.
All manuals and user guides at all-guides.com
Summary of Contents for EURODESK MX9000 User's
