HEAVY DISTORTION HD300
Thank you for showing your confidence in us by purchasing the BEHRINGER HEAVY
DISTORTION HD300. This high-quality effects pedal enables you to produce super thick,
tube-like distortion plus endless sustain. Thanks to its high-performance features you
can achieve the typical hard rock or heavy metal distortion sounds, when playing over
a clean amp channel.
1. CONTROLS
Top view
The LEVEL control adjusts the output level.
The TONE control allows you to shape your overall sound.
The BOTTOM control allows you to boost/cut the low-frequency range.
The DIST(ortion) control adjusts the amount of distortion.
The GAIN BOOST control adjusts the gain for more extreme distortion sounds.
The ON/BATT LED illuminates when the effect is activated. It also serves as a
battery level indicator.
Use the footswitch to activate/deactivate the effect.
Use this 1/4" TS IN connector to plug in the instrument cable.
The 1/4" TS OUT connector sends the signal to your amp.
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or
replace the 9 V battery (not included), press the hinges with a ballpoint pen and remove
the pedal cover. Be careful not to scratch the unit.
The HD300 has no on/off switch. As soon as you insert the plug into the IN
connector, the HD300 is on. When not in use, remove the plug from the IN
connector. This extends the life of the battery.
