GN-9371_2_3 User Manual
Page 5 of (110)
G-series GN-9371_2_3 PIO Rev. 1.02.docx
1 Important Notes
Solid state equipment has operational characteristics differing from those of electromechanical equipment.
Safety Guidelines for the Application, Installation and Maintenance of Solid State Controls describes some
important differences between solid state equipment and hard-wired electromechanical devices.
Because of this difference, and also because of the wide variety of uses for solid state equipment, all persons
responsible for applying this equipment must satisfy themselves that each intended application of this equipment
is acceptable.
In no event will CREVIS be responsible or liable for indirect or consequential damages resulting from the use or
application of this equipment.
The examples and diagrams in this manual are included solely for illustrative purposes. Because of the many
variables and requirements associated with any particular installation, CREVIS cannot assume responsibility or
liability for actual use based on the examples and diagrams.
If you don’t follow the directions, it could cause a personal injury, damage to the equipment or
explosion
•
Do not assemble the products and wire with power applied to the system. Else it may cause an electric arc,
which can result into unexpected and potentially dangerous action by field devices. Arching is explosion risk in
hazardous locations. Be sure that the area is non-hazardous or remove system power appropriately before
assembling or wiring the modules.
•
Do not touch any terminal blocks or IO modules when system is running. Else it may cause the unit to an
electric shock or malfunction.
•
Keep away from the strange metallic materials not related to the unit and wiring works should be controlled by
the electric expert engineer. Else it may cause the unit to a fire, electric shock or malfunction.
If you disobey the instructions, there may be possibility of personal injury, damage to equipment or
explosion. Please follow below Instructions.
•
Check the rated voltage and terminal array before wiring. Avoid the circumstances over 60
℃
of temperature.
Avoid placing it directly in the sunlight.
•
Avoid the place under circumstances over 90% of humidity.
•
Do not place Modules near by the inflammable material. Else it may cause a fire.
•
Do not permit any vibration approaching it directly.
•
Go through module specification carefully, ensure inputs, output connections are made with the specifications.
Use standard cables for wiring.
•
Use Product under pollution degree 2 environment.
Warning!
Caution!
