Operation
Beijer Electronics, MAEN945B
17
6.3 Bench and Function Tests
Set dip switches
SW3
and
SW4 = OFF
to be able to run the bench and function
tests for the H-T40m. Turn on the operator terminal to display the following
screen:
The bench test performs an overall hardware test, and the function test lets the
user select which item to be tested.
6.4 Setting Communication Parameters
There are two ways to configure working parameters; to set parameters in the
operator terminal or in H-Designer.
To set parameters in the operator terminal, select
Confg
in the system menu.
To set parameters in H-Designer, select
Application/Workstation Setup
. Select
the
Connection
tab to set communication parameters.
Note:
The bench test will clear the application data of the operator terminal.
Note:
Remember to set dip switch
SW5 = ON
if parameters are set in the operator
terminal.
Note:
Remember to set dip switch
SW5 = OFF
if parameters are set in H-Designer.
