X2 Control communication with BFI-E3 by Modbus TCP
SER0020_V1.0.0 2020-11
18 (31)
Nor
m
a
l.d
o
tm
,
2
0
2
0
-07
-01
3
:
Response Timeout
The response timeout sets the time interval that the master will wait for the answer from a slave node. If
the nodes do not answer within this time interval, then an error is recorded for the implicit slave function
block. The value entered for the time interval is also the default value for each node. For each node, you
can still set a specific value within its Modbus TCP slave configuration.
4
:
Socket Timeout
Maximum time to wait for incoming TCP/IP packages. The bus cycle task can be blocked during this
time, for example if a Modbus TCP slave is disconnected.
5
:
Auto-reconnect
When a slave is missing in the network the master tries to automatically reconnect.
6
:
IP Address of the BFI. Must correspond to the settings in the option module inside BFI set by software
IP Config.
7
:
Time interval for the master to wait for the response from the slave. This is especially configured for
this slave node and overwrites the general response timeout setting of the respective master.
8
:
Port number (TCP/IP) of the slave 502 is default for Modbus
