X2 Control communication with BFI-E3 by Modbus TCP
SER0020_V1.0.0 2020-11
4 (31)
Nor
m
a
l.d
o
tm
,
2
0
2
0
-07
-01
4
System set up
Here comes a short description of what needs to be done and what tools are to be used to make X2
control work together with one or several BFI-E3-
…..
-MTP in a Modbus TCP network:
1.
Set up of IP-address of BFI-E3-
……
-MTP
.
Use the Web browser in BFI-E3 and IP address 192.168.1.253. Make sure IP-address
corresponds with the BFI-E3 setting in CODESYS/BCS Tools. See chapter
2.
Set up parameters in BFI-
E3….
-MTP
Either set them up on the display of BFI-E3, PC software BFI-Tools or a device with BFI-Tools
Mobile. See chapter
3.
Software enable needs to be activated by a jumper between terminal 1 and 2 of BFI-E3
4.
Set up the IP-address of X2 control. See chapter
5.
Connect the patch cable from X2 control, port LAN B, to ethernet port P1 of BFI-E3
6.
Download the PLC-project to X2 control.
Use BCS Tools 3.30 or later or CODESYS V3.5
SP13 Patch3 for the PLC-project.
7.
Download the iX-project to X2 control.
Use iX Developer 2.40 SP5 or later.
