Chapter 10 JF type sequin embroidery
(3)
Auto start for sequin:
When the setting is “Yes”, system will start embroidering sequin automatically.
When the setting is “No”, machine needs manually start.
(4)
Time of Sequin Action:
This is to set the time from sequin device going down to embroidery (0-15, the default value is
2). If the sequin-feeding device is controlled by valve, please use the default value; if that device
is controlled by motor, please select 4-5.
(5)
Sequin off after T.B.(T.B: Thread-breakage)
When the setting is “Yes”, sequin presser foot will go up automatically in case of thread breaks.
When the setting is “No”, user needs manually lift the presser foot.
(6)
Sequin Ind. Up Down
When the setting is “Yes”, the action of the sequin device will be independent. When the setting
is “No”, the action will be collective.
(7)
Up Valve When Jump & Nocut.(No,Yes)
(8)
L/R Motor Shift Stroke Base.
(9)
L/R Motor Shift Stroke Time.
(10)
With Origin at L/R Motor Shift.
The parameters No.8, No.9 and No.10 at above are for the special sequin device which uses the
motor of single needle dual-sequin device to shift the travel amounts of large sequin and small
sequin. This kind of device contains two types: the one is with shift origin; the other is without
that shift origin.
(11)
L/R Knife Start Angle Adj.
This parameter is for the special sequin device using the motor to cut the sequin, which can
adjust the start time of the sequin-cutting motor. The default value of this parameter is 15. The
smaller this value is, the earlier the motor will be activated (Min value is 0); the larger this value
is, the later the motor will be activated (Max value is 31).
(12)
Bead-breakage Detection Sensitivity.
This parameter is for the beam embroidery device. “0” means to turn off the sensitivity of the
beam-breakage detection. The range of this parameter is 0~10. “1” means the highest sensitivity,
while “10” means the lowest sensitivity.
BECS-D56 computerized embroidery machine owner’s manual
115
Summary of Contents for BECS-D56
Page 2: ......