Chapter 10 JF type sequin embroidery
Setting of sequin-feeding mode:
a)
Press digital key confirm embroidery needle position, it will show “input sequin mode”
at the position that has sequin device.
b)
Use
or
to modify the delivery mode and press “
”to confirm. A stands
for front motor delivery; B stands for middle motor delivery and C stands for rear
motor delivery. AC stands for front/rear motor overlapped sequin, AB stands for
front/middle motor overlapped sequin, BC stands for middle/rear motor overlapped
sequin and ABC stands for front/middle/rear motor overlapped sequin.
Note: if there are only two motors, then B stands for rear motor.
c)
After pressing “
”, you should input the number of sequin for feeding. If it requires
same mode before color-changing code, then type in “1” and press “
”.
d)
Press
or
till you see “Over” in “input sequin mode”, then press “
”to
confirm.
For example: a machine with needle 9 as its end needle (sequins 3, 5, 7mm); first
needle is single sequin (9mm). The requirement is sewing a 7mm sequin at first,
then a 3 & 5mm overlapped sequin, then a 5 and 7mm alternative embroidery, then
9ps of 3mm sequin, 8ps of 5mm sequin, 4ps of 7mm sequin, 6ps of 3mm & 7mm
overlapped sequins. At last, use first needle to embroider a 9mm sequins.
Settings:
(
1
)
①
press 9
,
it will show sequin delivery mode screen
;
118 BECS- D56 computerized embroidery machine owner’s manual
Summary of Contents for BECS-D56
Page 2: ......