Chapter 5 Management of Machine Parameters
When the parameter
“
To Do Cyclic Emb.
”
is set as
“
Yes
”
, the cyclic embroidery function is
enabled and the icon
will appear in the main screen. When this function is enabled, after
completing the designated design, the machine will automatically embroider it again without
pulling the bar.
Usually, cyclic embroidery accompanies repetition embroidery or special punched designs, and
the parameter
“
Auto Origin
”
should be also set as
“
Yes
”
. Thus when the machine is
embroidering the back embroidery cloth-piece, the front one can be replaced by user. After
embroidering the designated design, the frame will automatically return to the start point and
the machine will automatically embroider the front cloth-piece again and at this time it’s
possible to replace the back one.
2.
Store Manual Color-changing
In embroidery confirmation status, the user can choose whether to store the manual
color-changing’s needle position into the color-changing order unit. Its purposes are as followed:
1) If mistakes are found at the automatic color-changing order during embroidery, the
color-changing order can be modified with manual color-changing. 2) When a new design is
embroidered with manual color-changing once, the color-changing order is set for the design.
To use this function, the user should set the parameter “Store Manual Color” as “Yes”. Note: the
parameter value will automatically change into “No” at the end of embroidery of one design.
3.
Forbidding Design Output
The function is to forbid unauthorized copy of the designs in memory (into the disk). If the
machine administrator set “No Output Design” as “Yes”, other persons are unable to output the
designs to the disk. If the user needs to output, he will have to cancel “No Output Design” at
first.
5-3
Set User-defined parameter
This function should be used with “select user-defined parameter from all”. “Set
user-defined parameter” makes it easy to set the frequently changed parameters.
The setting should follow the steps as below:
1.
Press the key“
” in the main screen, move the cursor to “select user-defined parameter
from all”.
60 BECS- D56 computerized embroidery machine owner’s manual
Summary of Contents for BECS-D56
Page 2: ......