Copyright © 2019 TTAAll Rights Reserved.
Product Introduction
13
1) Arm M1-M6 should be matched with copter’s.
2)
Match the arm’s MT60 female connector with copter’s MT60 male connector,see
figure 8.
3) Match 6mm inner hole of arm clamp with copter’s main part 6mm inner hole,see figure
9.
Female and
male matched
Figure 8
figure 9
4) Install the M5*49 plug screw from the hexagon side of the 6mm hole on fuselage arm
joint,see figure 10 .
5
）
Lock the plug screw with a M5 nut from the other side,the bolt end should same as the
the nut,that means lock works, as Figure 11
Bolt on hex hole
Nut in hole
M5 shutter screw
M5 nut
Self lock when bolt end and
nut in same plane
Figure 10
figure 11
5) Install the rest 5 arms as above , it will be completed like Figure 12.
6) Fix the camera module on the heading position as Figure 13.
