Page 2
Precautions
Read the following security precautions carefully to prevent any risk of product damage and personal
injury, and thoroughly once more before using the STM001 printer.
Keep them in a safe place so that they can be read by someone new before they use the
ap pli an c e.
Turn the appliance off in case of malfunctioning.
If you detect any smoke or pungent or unusual odour from the appliance or power supply (accessory
supplied),
turn it off immediately, disconnect it from the mains, and send it to the nearest Service Center.
Do not try to disassemble the appliance.
Contact with internal components can cause injury. In case of faults the product must only be repaired by
qualified personnel.
If the appliance is broken due to a fall or crash, contact the Service Center to repair it.
Observe due precautions while handling the batteries.
The batteries should never be exposed to high temperatures, that is, over +60°C.
In order to ensure an optimum service life, use them at environment temperature.
If used at low temperatures their service life could diminish.
Never take apart the batteries; do not throw them into fire as they could explode.
Do not dispose of the batteries as normal waste. Follow local regulations on their disposal.
Use the correct cables supplied.
To ensure product conforms to norms, only use the correct cables supplied or those marketed separately
by BEINAT S.r.l. for terminal input/output connection.
In order to achieve long and satisfactory use of your STM001 printer, use and store it by respecting the
following precautions.
CHECK the integrity of the printer after having removed it from the box.
Any use of the printer for purposes other than the intended one is considered improper, and as a result
of which BEINAT S.r.l. therefore disclaims any responsibility for possible damages caused to people,
animals or objects.
Do not allow it to become wet.
The printer can be seriously damaged as it is not waterproof either when immersed in water or exposed
to high levels of humidity.
Do not drop it.
Heavy knocks on hard surfaces and strong vibrations can damage the appliance.
Avoid strong magnetic fields.
This printer should not be used or stored near radiation, or intense magnetic fields. Static electricity or
magnetic fields generated by appliances such as radio transmitters can interfere during printing.
Avoid abrupt temperature fluctuations.
Sudden temperature variations can cause condensation and the batteries could supply a lower voltage.
Clean in g
Never clean the device with chemical products. If necessary, wash with a moist cloth.
For Your Security
