1-19
6.4
Additional settings at the operation device
The operator may not open the Setup pages of the machine control. This
should be preserved to especially educated and experienced technicians.
You have to enter the machine code to open the Setup pages.
Attention
Damage to the machine due to inadequate programming possible! The
machine code should be kept secret and accessible to persons only, who are
allowed to program and setup the machine.
Only two settings may be executed by the operator:
•
select the operation language;
•
adjust display contrast.
6.4.1
Select operation language
Position the cursor on the program number and press the Minus key once.
This will be displayed:
: 3400
[ ]
XXX
DEUTSCH
000
PROG.
Use the arrow keys to move the cursor on the displayed operation language
(here: deutsch = german) and press the Plus key, until the desired operation
language is displayed.
Move the cursor back on „000“.
Hint
The descriptions in the sewing programs will always be displayed in the
language that had been used to enter them.
6.4.2
Adjust display contrast
Open page „Program 000“ (see 6.4.1) and position the cursor on the half-
filled circle symbol. Press the Plus or Minus key to adjust the contrast of the
display.
Position the cursor on „000“ and press the Plus key to select a sewing
program.
Summary of Contents for 1500/70 Series
Page 24: ...1 22 ...
