1 692 846 001
2017-04-27
|
Beissbarth GmbH
Maintenance | VLH 4440 | 41
en
8.3
Spare and wearing parts
Item/Component
Order number
Hydraulic fluid
(mineral fluid ISO 46, 5 litres)
1 692 872 372
8.4
Maintenance by the user
The maintenance work described below must be
performed by the user.
!
Prior to maintenance, the platform must always be
disconnected from the mains and secured to prevent
unauthorized use.
!
If components are damaged or worn or do not
function properly:
Inform Beissbarth customer service or an authorized
service agent.
8.4.1
Maintenance agreement
i
Regular upkeep of the lifting platform is essential to
ensure a long service life and permanent readiness
for use. We recommend concluding a maintenance
agreement with Beissbarth customer service or an
authorized service agent.
8.4.2
Maintenance schedule
Interval: T = Daily; W = Weekly; M = Monthly; 6M = Every
6 months; J = Annually; 6J = Every 6 years.
Int
er
val
Component
Action
T
Stickers
Visual inspection:
All stickers must be affixed and
clearly legible.
T
Drive-on ramps and
roll-off guards
Visual inspection: Components must
not be damaged.
T
Wiring
Visual inspection:
No damage to insulation.
T
Hydraulic system
Visual inspection:
No escape of fluid.
T
Compressed air
service unit
Drain condensate. Clean filter if
necessary. Check fluid level.
T
Detent pins
Functional test:
Detent pins must extend and retract
properly.
M
Exposed surfaces
and edges
Cleaning:
Clean all contaminated surfaces
and apply preservative agent if
applicable.
M
Exposed surfaces
and edges
Paintwork care:
Sand down paintwork blemishes
with sand paper (grain size 120)
and touch up with the appropriate
RAL shade.
M
Suspension cables
and pulleys
Visual inspection:
Components must not be damaged
or worn.
Typical examples of cable damage:
Individual wire breaks, corrosion,
kinking, constriction, flattening,
looping, tangling.
Pay particular attention to cables in
area of threaded end pieces (under
end plate).
M
Slack cable safety
system
Functional test:
Actuate slack cable switch.
M
Cable break safety
system
Functional test:
Check freedom of movement of
locking mechanism.
M
Foot protection
safety level
Functional test:
Raise the lifting platform and lower
it again.
6M Hydraulic unit
Check fluid level in tank. Top up with
specified hydraulic fluid if necessary.
6M Moving components Check lubrication:
Lubricate all moving components
as per lubrication chart.
6M Shear connectors
Check strength.
Tightening torque M12 = 60 Nm.
Re-tighten if necessary.
J
Hydraulic unit
Change hydraulic fluid.
Only ever use organic hydraulic fluid.
J
Hydraulic unit
Have hydraulic hoses checked by
VBG14.
6J Hydraulic unit
Replace hydraulic hoses.