Page
4
of
17
III. Installation
3.1 Installing combs and cutters
3.1.1 Combs
Place the comb on the cutting head of the handpiece, make sure the comb and the
cutting head is properly aligned and symmetrical. At this stage do not tighten the
comb screw, apply limited pressure just enough to hold the comb in place.
3.1.2 Cutters
Insert cutter then tighten the tension nut, until the tips of the chickenfeet fit firmly into
the two holes on both sides of the cutter.
3.1.3 Adjusting and securing comb
Adjust the relative positions of the comb and cutter, ensure the point at which the
bevel of the comb begins is 1.5 to 2 mm from the tip of the middle tooth of the cutter
(see fig.1). Also ensure that the comb and cutter is symmetrically positioned, then
secure the comb firmly using the provided spanner.
Fig. 1
