Appendix
Operating manual CARLO EP & Classic
V2.10 E
Page 44 of 56
13.7 Mounting instructions
13.7.1 Rear Castor Replacement
Image 1:
Required tools:
1 x 10 mm Allen
wrench
Image 2:
Additional parts/tools:
1 x rear castor
(Order number
S9200130)
1 x thread lock fluid
(medium tight)
Image 3:
Put an object (e.g.
wooden block) under
the side where you
want to replace the
castor to free the
castor.
Image 4:
Unscrew the screw of
the castor using the
Allen wrench.
Image 5:
Remove the screw of
the castor. Hold the
castor back with your
hand! Remove the
castor with the screw
Image 6:
Remove the cover
plate with thread and
fixing pins. Caution,
the fixing pins are
loose. Make sure you
do not lose a fixing
pin!
Image 7:
Prior to screwing a
new castor, you must
apply thread lock fluid
(
medium tight at
least 21 Nm
) to the
thread of the screw.
Caution: the thread lock fluid must dry at least 3 hours before the device can be
loaded.
Should you use thread lock fluid from another manufacturer, the drying times
specified by this manufacturer must be observed!
Re-assemble in reversed order!
