Unpacking and assembly
User Manual AVERO Premium Plus V2.4 E
Seite
15
von
58
4.5
Adjusting the thermostat mixer (scald protection)
Figure 1:
Tools you need:
1 x screwdriver flat,
0,6 x 3,5 mm,
1 Screwdriver Cross-
hatch,
1 x thermometer
Figure 2:
Turn the knob to the
left until it stops (Snap
button not pressed)
Figure 3:
Use the screwdriver to
remove the cap
Figure 4:
Unscrew the cross
screw from the rotary
actuator and pull it
forwards.
Figure 5:
Open a solenoid valve
to check the water
temperature
(In the pictures shown
handbrake).
Figure 6:
Check the outlet
temperature with the
external thermometer!
Figure 7:
Adjust the water to the
desired maximum
discharge
temperature.
Figure 8:
The picture shows the
desired maximum
temperature, which
must agree with the
manually measured
temperature.
Figure 9:
Slide the knob to the
maximum position.
Figure 10:
Switch off the solenoid
valve.
Figure 11:
Install the rotary knob
with the cross bolt
Figure 12:
Reinsert the cover.
!!!!
!
