Operating
User Manual AVERO Premium Plus V2.4 E
Seite
29
von
58
10.2 Display (2) / Display (3) / Display (4)
On the built-in digital display the following is shown:
Display (2) = Handheld showerhead temperature
Display (3) = Filling temperature
Display (4) = Bath water temperature
The display is shown in 0.5 °C increments.
If the measured temperature greater than 42 °C (scald protection), then the
appropriate display "HOT" alternating with the temperature is displayed.
The temperature is displayed in a range from 2.5 °C (32.5 °F) to 64.0 °C (99.5 °F).
If the temperature is less than 2.5 °C "TLO" will appear.
If the temperature is more than 64.0 °C "TLO" will appear.
10.3 Handheld showerhead button (5)
The Handheld showerhead is switched on or off by pressing button (5).
The Handheld showerhead is switched off automatically when the temperature
of the Handheld showerhead 42 °C is greater (scald protection, display flashes "HOT").
If the scald protection activates (temperature display flashes "HOT"), the handheld
showerhead cannot be turned on using the button (5).
The handheld showerhead can be switched on or off with the following key combination:
Hold and press button (5), press additional keys (8) and (10) together.
The handheld showerhead can always be turned off using the button (5) (also with an
active scald protection).
10.4 Fill level 1 button (6) + fill level 2 button (7) (option)
There are 2 fixed fill levels for filling the bath that can be selected.
Pressing the button (6) begins filling the tub up to the defined Fill level 1.
Pressing the button (7) begins filling the tub up to the defined Fill level 2 (max.
automatic fill level).
Stopping filling both levels (Fill level 1 and 2) is achieved by pressing the
previously selected fill level.
To start filling again, press the corresponding button again. The function is disabled when
the chosen filling level has been reached.
