15
6. OPERATION AS A TIMER
When configured as a Timer the BA377NE can
measure and display the elapsed time between
external events such as measuring and displaying
how long machinery is operating. The Timer can be
started and stopped by a remote sensor, or from the
front panel push buttons.
The addition of two optional factory fitted isolated
control outputs allows the Timer to control external
events such as opening a valve for a predetermined
time. Again the Timer can be started and stopped
by a remote sensor, or from the front panel push
buttons.
When controlling external events the
CYCLE
function
enables the BA377NE Timer to be configured to
repeat the timing period up to 99 times with a
configurable delay between timed periods up to 100
hours or to repeat continuously.
The BA377NE may be configured to
time-up
from
zero to the set time
5Et t
, or to
time-down
from the
set time to zero. The set time may be entered and
displayed in hours, minutes or seconds, or a
combination of units. Elapsed or remaining time is
continuously displayed and a separate display may
be activated to show the Timer set time
5Et t
.
Resetting the timer cycle can be accomplished via
the front panel push buttons or by a remote contact.
A grand total time is maintained which can be
viewed by operating the front panel push buttons. It
may be reset to zero from within the configuration
menu, or the instrument may be configured to allow
resetting from the front panel push buttons.
Fig 11 shows a simplified block diagram of the
BA377NE when configured as a Timer. The input
can be configured to accept inputs from a wide
variety of sensors.
When the sensor requires
energising, such as a switch contact, open collector
or a two wire proximity detector, a link connected
between terminals 3 & 4 supplies power to the
sensor input.
The instrument can be supplied with the following
factory fitted accessories:
Internally powered Backlight
Dual isolated Control Outputs
The two factory fitted solid state isolated control
outputs may be independently configured to close
and open at specified parts of the timer cycle, such
as when the timer starts or finishes.
6.1
Initialisation
Each time power is applied to a BA377NE
initialisation is performed. After a short delay the
following display sequence occurs:
All segments of the display are activated
BA377NE is ready to start functioning using
the configuration information stored in the
instrument's permanent memory.
Fig 11 BA377NE block diagram with Timer
configuration.
Summary of Contents for BA377NE
