18
6.5
Configuration as a Timer
The BA377NE is configured via the four front panel
push buttons.
All the configuration functions are
contained in an easy to use intuitive menu that is
shown diagrammatically in Fig 13.
Each menu function is summarised in section 6.5.2
of this manual and each summary includes a
reference to more detailed information.
All
new
BA377NE
instruments
are
supplied
configured as requested at the time of ordering. If
configuration is not requested, the BA377NE will be
supplied with default Timer configuration as shown
below, but the instrument can easily be re-
configured on-site.
Function
Display
Default
Access code
CodE
0000
Function
FunCtion
ELAP5E
Input
inPut
oP
.
CoL
Debounce
dEbounCE
dEFAuLt
Display 2
di5P-2
5td
Start stop
5tAr5toP
LoCAL
Units
unit5
12
:
00
:
00
Set time
5Et t
00
:
00
:
00
Enable repeat cycle
CYCLE5
oFF
Access set time from
AC5Et t
oFF
display mode.
Direction of count
uP or dn
dn
Recovery from power
p-fail
idle
supply failure.
Local total reset
t-rE5Et
on
Local grand total reset
Gt-rE5Et
oFF
External reset
E-r5et
5td
Enable control output 1
*
EnbL
oFF
Enable control output 2
*
EnbL
oFF
*
Optional output
6.5.1
Accessing configuration functions
Throughout this manual front panel push buttons are
shown as
&
,
*
,
(
and
)
and legends
displayed by the instrument are shown in a seven
segment font just as they appear on the instrument
e.g.
inPut
and
Clr Gtot
.
Access to the configuration menu is obtained by
operating
the
(
and
)
push
buttons
simultaneously. If the instrument is not protected by
an access security code the first parameter
FunCtion
will be displayed. If a security code other
than the default code
0000
has already been
entered, the instrument will display
CodE
.
Press
(
to clear this prompt and enter the security code
for the instrument using the
&
or
*
push button to
adjust the flashing digit and the
(
push button to
transfer control to the next digit. If the correct code
has been entered pressing
)
will cause the first
parameter
FunCtion
to be displayed. If an incorrect
code is entered, or a push button is not operated
within ten seconds, the instrument will automatically
return to the display mode.
All configuration functions and prompts are shown
on the upper eight digit display.
Once within the main configuration menu the
required function can be selected by scrolling
through the menu using the
&
or
*
push button.
The
Timer
configuration
menu
is
shown
diagrammatically in Fig 13.
When returning to the display mode following
reconfiguration, the Timer will display
dAtA
followed
by
5AVE
while the new information is stored in
permanent memory.
Summary of Contents for BA377NE
