12
Four panel mounting clips should be used
Minimum panel thickness should be
Edges of panel cut-out should be deburred and clean
Each panel mounting clip should be
To maintain IP66 protection between the BA418CF and the mounting panel:
Outside panel finish should be smooth, free from particle inclusions, runs or
tightened to between:
build-up around cut-out.
Panel cut-out should be
5.
cont:
3mm (0.12inches) Aluminium
(2.60 x 5.35 inches –0.00 +0.02)
20 and 22cNm (1.77 to 1.95 inL
2mm (0.08inches) Steel
66.2 x 136.0mm -0.0 +0.5
b)
The BA414DF and BA418CF should be mounted where they are shielded from
The terminator on the Fieldbus must be FM or for Canadian installations CFM or
REMKE hub
O-Z / Gedrey Hubs
the required environmental protection.
Crouse – Hinds Myler hubs
CHMG-50DT
Metallic glands and hubs must be grounded – see note 7.
CMCXAA050 MCR050 MCX050
all metalic glands or conduit hubs must be connected together and grounded.
Killark Glands
SSTG-1 STG-1 STAG-1
Any metallic or plastic cable gland or conduit hub that provides
When installed in a hazardous (classified) location the BA414DF Fieldbus
Indicators shall be fitted with cable glands / conduit hubs selected from the following table
In addition to the supplied bonding plate, when 3 metallic glands or conduit
hubs are fitted to a BA414DF Fieldbus Indictors,
The BA414DF and BA418CF Fieldbus Indicator enclosures are
manufactured from conductive plastic per Article 250 of the National Electrical
Code the enclosures shall be grounded using the ‘E’ terminal on the terminal
block.
10.
9.
Class II and III
Class I
CAUTION:
7.
8.
WH-1-G
MHUB-1
Class
6.
Permitted gland or conduit hub
CSA Approved.
direct sunlight.
