14 / EN
Cooker Hood / User Manual
5.4 Connecting to Chimney
(Figure 10)
1. Flap Pin Socket
2. Flap Pin
Insert the plastic pin (Figure 10/area no. 2) on the
pin socket on the motor exhaust (Figure 10/area
no.1). Then bend the flap lightly to insert the other
pin on the flap and insert the other pin to its socket
(Figure 10).
If you are going to use the Ø 120/150 mm plastic
Chimney adapter, connect one end of the pipe to
this adapter, if you are not going to use it, to the
direct output on the product. Connect the other
end of the pipe to your chimney. Check that these
two connections are tight enough so they will not
come out when the appliance runs on full power.
Ensure that the flaps inside the Chimney work
when tightened with clamp. Connect the Chimney
connection duct outside the adapter (Figure 11/a).
If the connection duct is fitted inside the adapter,
suction of air shall not occur as the Chimney flap
that prevents the return of air will remain closed
(Figure 11 / b). The length of the pipe connection
as well as the number of elbows must be as min-
imum as possible.
A : Chimney exit pipe
B : Chimney Clamps
C: Plastic Chimney
The valves are closed then the appliance is not
operating and prevent possible outside odour and
dust from entering inside.
Ok
Not Ok
(a)
(b)
(Figure 11)
5.5 Installation of the Hood to the
Chimney
Make the electrical connection of your hood be-
fore starting the installation of the chimney. Slip
the Chimney plates around the body. Screw the
Chimney to the Chimney fastening plates availa-
ble on the motor cabin. (Figure 12).
Install the Chimney to the Chimney fastening plate
that is secured to the wall from its upper outer
edges (Figure 12).
(Figure 12)
5
Installation of appliance
Summary of Contents for 01M-8897233200-0722-13
Page 84: ... ...
Page 85: ... ...
Page 289: ...Arçelik A Ş Karaağaç Caddesi No 2 6 34445 Sütlüce İstanbul Türkiye www beko com ...
