EN / 15
Washing Machine / User’s Manual
6. Installation
6.1 Appropriate installation location
WARNING!
• Damaged products cause risks for your safety.
- Prior to installation, visually check if the product has any
defects on it.
- If so, do not have it installed.
CAUTION!
• Do not place the product on a floor without sufficient
capacity to carry the load.
- Otherwise, the product or the floor may be damaged.
- Total weight of the washing machine and the dryer -with
full load- when they are placed on top of each other is
approx. 180 kilograms.
• Do not install the product in places where there is the risk
of freezing.
- Otherwise, your product will be damaged and your house
will be under risk of flood.
NOTE
• Preparation of the location and electrical, tap water and
waste water installations at the place of installation is
under customer's responsibility. Refer to the nearest
Authorised Service Agent for installation of the product
after those preparations are complete.
• Make sure that the water inlet and drain hoses as well as
the power cable are not folded, pinched or crushed while
pushing the product into its place after installation or
cleaning procedures.
• Manufacturer shall not be held liable for damages that may
arise from procedures carried out by unauthorised persons.
a) Place the product on a rigid, flat and level surface.
b) Never place the product on a carpet-covered floor.
c) Leaving a gap at the sides of the machine is suggested to reduce
vibration and noise
d) Do not place the product on any platform.
e) Do not place heat sources such as Hobs, Irons, Ovens, etc. on the
washing machine and do not use them on the product.
Summary of Contents for 1-WTV9734XW
Page 56: ...www beko com ...