Beko 7001440027, User Manual

9 / EN

Washing Machine / User Manual

4.1.7 Electrical connection

Connect the product to a grounded outlet protected by a 13 A fuse. Our company shall not be liable for any 

damages that will arise when the product is used without grounding in accordance with the local regulations.

•  Connection must comply with national regulations.

•  The wiring for the electrical outlet circuit must be sufficient to meet the appliance requirements. Use of a 

Groud Fault Circuit Interrupter (GFCI) is recommended.

•  Power cable plug must be within easy reach after installation.

•  If the current value of the fuse or breaker in the house is less than 13 Amps, have a qualified electrician 

install a 13 Amp fuse.

•  The voltage specified in the “Technical specifications” section must be equal to your mains voltage.

•  Do not make connections via extension cables or multi-plugs.

B

WARNING: 

Damaged power cables must be replaced by Authorised Service Agents.

Electrical requirements 

Before you insert the plug into the wall socket make sure that the voltage and the frequency shown in the 

rating label corresponds to your electricity supply.

We recommend that this appliance be connected to the mains supply via a suitable switched and fused socket 

in a readily accessible position.

Should the mains lead of the appliance become damaged or need replacing at any time, it must be replaced 

by a special purpose made mains lead which can only be obtained from an Authorised Service Agent.

B

WARNING: 

This appliance must be earthed

If the fitted moulded plug is not suitable for your socket, then the plug should be cut off and an appropriate 

plug fitted.

Destroy the old plug, a cut off plug with a bare cord could cause a shock hazard if inserted into a socket 

elsewhere in the house.

The moulded plug on this appliance incorporates a 13A fuse. Should the fuse need to be replaced an ASTA 

approved BS1362 fuse of the same rating must be used. Do not forget to refit the fuse cover. In the event of 

losing the fuse cover, the plug must not be used until a replacement fuse cover has been fitted. Colour of the 

replacement fuse cover must be the same colour as that visible on the pin face of the plug. Fuse covers are 

available from any good electrical store.

Important

Fitting a different plug

As the colours of the wires in the mains lead of this appliance may not 
correspond with the coloured markings identifying the terminals on your 
plug, proceed as follows:
1 

Connect the green - yellow or green (earth) wire to the terminal in 

the plug marked ‘E’ or with the symbol 

 or coloured green and 

yellow or green.

2 

Connect the blue (neutral) wire to the terminal in the plug marked 

‘N’ or coloured black.

3 

Connect the brown (live) wire to the terminal in the plug marked ‘L’ 

or coloured red.

With the alternative plugs a 13A fuse must be fitted either in the plug or 
adaptor or in the main fuse box. If in doubt contact a qualified electrician.