12/EN
3
Installation
Product must be installed by a qualified
person in accordance with the
regulations in force. The manufacturer
shall not be held responsible for
damages arising from procedures
carried out by unauthorized persons
which may also void the warranty.
Preparation of location and
electrical and gas installation for
the product is under the installer's
responsibility.
The product must be installed in
accordance with all local gas
and/or electrical regulations.
Prior to installation, visually check
if the product has any defects on
it. If so, do not have it installed.
Damaged products cause risks
for your safety.
Before installation
The hob is designed for installation into
commercially available work tops. A
safety distance must be left between the
appliance and the kitchen walls and
furniture. See figure
(values in mm).
•
It can also be used in a free standing
position. Allow a minimum distance of
750 mm above the hob surface.
•
(*) If a cooker hood is to be installed
above the cooker, refer to cooker
hood manufacturer' instructions
regarding installation height (min 650
mm)
•
Remove packaging materials and
transport locks.
•
Surfaces, synthetic laminates and
adhesives used must be heat resistant
(100 °C minimum).
•
The worktop must be aligned and
fixed horizontally.
•
Cut aperture for the hob in worktop as
per installation dimensions.
Summary of Contents for 7754786326
