Beko 8690842374609, User Manual

45 / EN

Washing Machine / User Manual

4.3.16 Cancelling the programme

To cancel the programme, turn the Programme 

Selection knob to select another programme. 

Previous programme will be cancelled. End/

Cancel light will flash continuously to notify that 

the programme has been cancelled. 
When you turn the Programme Selection knob, 

the machine will end the programme but will not 

discharge the water inside. When you select 

and start a new programme, the newly selected 

programme will start depending on the step 

the previous programme was cancelled in. For 

example, the machine may take in additional 

water or continue to wash with the water inside.

C

INFORMATION

•  Depending on the step where the 

programme was cancelled in, you may have 

to add detergent and softener again for the 

programme you have selected anew.

4.3.17 End of programme

At the end of the programme, “End” will be 

displayed. 
1.  Wait until the light of the loading door goes 

off completely.

2.  Switch the programme selection knob to 

On/Off to switch off the machine.

3.  Take out your laundry and close the loading 

door. Your machine is now ready for the 

next washing cycle.

4.3.18 Your machine has the 

"Pause Mode" function.

After using the On/Off button to switch on the 

machine, if you do not start any programme in 

the selection step or do not perform anything 

else, or if you do not do anything in 10 minutes 

after the selected programme has ended, the 

machine will automatically switch to energy 

saving mode. Also, if your product has a display 

that shows programme time, this display will 

completely turn off. If you turn the Programme 

Selection knob or touch any button, the lights 

and the display will switch back to the previous 

position. The selections you make when exiting 

the energy efficiency mode may change. Check 

if your selections are correct before starting the 

programme. If necessary, make adjustments 

again. This is not an error.

4.4  Maintenance and cleaning

Service life of product extends and frequently 

experienced problems will be reduced if it is 

cleaned at regular intervals.

4.4.1 Cleaning the detergent drawer

Clean the detergent 

drawer at regular intervals 

(every 4-5 washing cycles) 

as shown below in order 

to prevent accumulation of 

powder detergent in time.

1.  Press the dotted point on the siphon in the 

softener compartment and pull towards you 

until the compartment is removed from the 

machine.

2.  Lift the rear part of the siphon to remove it 

as illustrated. If more than normal amount of 

water and softener mixture starts to gather 

in the softener compartment, the siphon 

must be cleaned.

3.  Wash the detergent drawer and the 

siphon with plenty of lukewarm water in a 

washbasin. In order to prevent the residues to 

contact your skin, clean it with an appropriate 

brush by wearing a pair of gloves.

4.  Insert the drawer back into its place after 

cleaning and make sure that it is seated well. 

4.4.2 Cleaning the loading 

door and the drum

For products with drum cleaning programme, 

please see Operating the product - 

Programmes.

C

INFORMATION

•  Repeat Drum Cleaning process in every 2 

months.

•  Use an detergent / anti-limescale suitable 

for the washing machines.

After every washing 

make sure that no foreign 

substance is left in the 

drum.

If the holes on the bellow shown in the figure is 

blocked, open the holes using a toothpick.