EN
12
4
Before operating
Starting
Final Check
Before you start using the freezer
check that:
1.
For a freestanding appliance;
‘this refrigerating appliance is not
intended to be used as a built-in
appliance’
2.
The front feet have been
adjusted so the appliance is level.
3.
The interior is dry and air can
circulate freely at the rear.
4.
Clean the interior as
recommended under “CLEANING AND
CARE.”
5.
Insert the plug into the
wall socket and switch on the
electricity supply. Avoid accidental
disconnection by taping over the
switch, the compressor will start
running in about five minutes.
6.
You will hear a noise as the
compressor starts up. The liquid and
gases sealed within the refrigeration
system may also give rise to noise,
whether the compressor is running or
not which is quite normal.
7.
Do not load the appliance
immediately it is switched on. Wait
until the correct storage temperature
has been reached. We recommend
that you check the temperature
with an accurate thermometer
(see;Temperature Control and
Adjustment)..
8.
Front edges of the cabinet may
feel warm. This is normal. These areas
are designed to be warm to avoid
condensation.
9.
We recommend that you set
the thermostat at MIN setting and
monitor the temperature to ensure
the appliance maintains desired
storage temperatures
10.
(See Temperature Control and
Adjustment section).
Important Notes :
11.
If there is a power failure
do not open the door. Frozen food
should not be affected if the failure
lasts for less than 17 hours. If the
failure is longer, then the food
should be checked and either eaten
immediately or cooked and then re-
frozen.
12.
If you find the freezer door
difficult to open just after you have
closed it, don’t worry. This is due to
the pressure difference which will
equalise and allow the door to open
normally after a few moments.
13.
You will hear a vacuum sound
just after closing the door. This is
quite normal.
14.
When you switch on, the
appliance will not start immediately,
because the
appliance
incorporates a protection device in
the electronics - wait for about 5
minutes.
15.
Since hot and humid air will not
directly penetrate into your product
when the doors are not opened,
your product will optimize itself in
conditions sufficient to protect your
food. Functions and components such
as compressor, fan, heater, defrost,
lighting, display and so on will operate
according to the needs to consume
minimum energy under these
circumstances.
