Electric Scooter / User Manual
5 / EN
1
Important safety and environmental instructions
Section 7 of the maintenance
specification in this operation
instructions. The electric scooter
may become unstable if the rear
brake is deformed or loose. This
is because the distance between
the brake pad and the rear wheel
becomes too small, possibly
leading to a blocked rear wheel.
•
Avoid applying too much force or
stepping on the rear fender per-
manently. This may cause the
fender to loosen or damage the
spring holding the fender. As a
result, the brake pad constantly
touches the wheel and the motor
temperature increases due to the
additional resistance. The rear tire
can also get loose if the brake is in
constant braking position.
•
Avoid constant braking. As a re-
sult, the tires will not only wear
off, but also become hot. This will
soften the rubber and it will no
longer have the same grip on the
road as usual. Do not touch the
tire after braking.
•
If the tire gets untight stop driv-
ing immediately and contact your
customer service.
•
Tire should be changed by the
independent operator or service.
•
Please change the tire at reg-
ular.
•
If you hear unusual noises or
notice friction when switching
on the electric scooter, a bearing
may be damaged. A worn bear-
ing may even be indicated by
strong vibration of the handlebar.
In this case,
•
Ride the electric scooter only on
a dry surface since otherwise
the riding safety and braking
performance may be impaired
and the motor or bearings may
be damaged.
•
Please do not ride up or down
long and steep slopes.
•
The scooter cannot use on the
steep road.
•
The e-scooter has overheating
protection system and maybe it
is activated on long slopes rid-
ing. please wait a while to reac-
tivate the product by power on
again.
•
Stop riding when you receive
the “Low Battery Warning”. The
electric scooter then moves only
