Beko B5T4923RW, User Manual

32 

Dryer / User manual

9. Electrical Connection

manufacturer, its service agent or similarly 

qualified people.

Do not operate without the top 

cover fitted. Risk of injury.

Important

9.3 Fitting a different plug 

As the colours of the wires in the mains 

lead of this appliance may not correspond 

with the coloured markings identifying the 

terminals on your plug, proceed as follows:
1 Connect the green - yellow or green (earth) 

wire to the terminal in the plug marked ‘E’ 

or with the symbol  or coloured green and 

yellow or green.
2 Connect the blue (neutral) wire to the 

terminal in the plug marked ‘N’ or coloured 

black.
3 Connect the brown (live) wire to the 

terminal in the plug marked ‘L’ or coloured 

red. 
With the alternative plugs a 13 A fuse must 

be fitted either in the plug or adaptor or in 

the main fuse box. If in doubt contact a 

qualified electrician.

Green and yellow

or green

N

Blue or black

L

Brown or red

9.4 Washer/dryer combination

Do not stack washing machine on top of 

the tumble dryer. This would damage both 

appliances and guarantees would become 

void. It is also unsafe to stack an appliance 

on top of another without using a suitable 

and approved stacking kit obtained from 

specialist retailers.

Make sure that you have an earthed power 

outlet socket rated at 13 amps (minimum).

9.1 Attention!

When installed, the socket must be 

reachable after installation, or a separate 

switch (which can disconnect the two poles) 

must be used in the installation. Check for 

suitability.
For a permanent connection, a master 

switch with at least 3mm contact clearance 

and minimum 13 A rating must be used.

9.2 Electrical requirements

Before you insert the plug into the wall 

socket make sure that the voltage and 

the frequency shown in the rating label 

corresponds to your electricity supply. 
We recommend that this appliance be 

connected to the mains supply via a suitable 

switched and fused socket in a readily 

accessible position. 
Should the mains lead of the appliance 

become damaged or need replacing at 

any time, it must be replaced by a special 

purpose made mains lead which can only be 

obtained from an Authorised Service Agent.

Warning

This appliance must be earthed 
If the fitted moulded plug is not suitable for 

your socket, then the plug should be cut off 

and an appropriate plug fitted. 

The moulded plug on this appliance 

incorporates a 13A fuse. Should the fuse 

need to be replaced an ASTA approved 

BS1362 fuse of the same rating must be 

used. Do not forget to refit the fuse cover. 

In the event of losing the fuse cover, the 

plug must not be used until a replacement 

fuse cover has been fitted. Colour of the 

replacement fuse cover must be the same 

colour as that visible on the pin face of the 

plug. Fuse covers are available from any 

good electrical store.
In order to avoid hazards, damaged 

supply cord should be replaced by the