Beko BCNSD160, Manual

EN

6

FITTED WITH

BS 1362 13A FUSE ALWAYS

FIT BS 1362 REPLACEMENT

CARTRIDGE FUSE

GREEN &

YELLOW

OR

GREEN

N

BLUE

OR

BLACK

L

BROWN

OR

RED

22mm.

6mm.

6mm.

6mm.

32mm.

12mm.

FUSE

CORD GRIP

Children shall not play with the 
appliance. Cleaning and user 
maintenance shall not be made by 
children without supervision.

•

  Children should be supervised to 

ensure that they do not play with the 
appliance.

Electrical requirements

Before you insert the plug into the wall 
socket make sure that the voltage and 
the frequency shown on the rating 
plate inside the appliance corresponds 
to yourelectricity supply.
Rating label is on the left hand side of 
fridge inner liner.
We recommend that this appliance be 
connected to the mains supply via a
Suitable switched and fused socket. 
The appliance must be positioned so 
that the plug is accessible.
WARNING: When positioning the 
appliance ensure the supply cord is 
not trapped or damaged.

Should the mains lead of the appliance 
become damaged or should it need
Replacing at any time, it must be 
replaced by a special purpose made 
mains lead which can only be obtained 
from a 

BEKO

 authorised service 

agent.

Warning! This appliance 

must be earthed

If the fitted moulded plug is not 
suitable for your socket, then the plug 
should be cut off and an appropriate 
plug fitted. Destroy the old plug which 
is cut off as a plug with bared cord 
could cause a shock hazard if inserted 
into a socket elsewhere in the house.
The moulded plug on this appliance 
incorporates a 13 A fuse. Should 
the fuse need to be replaced an 
ASTABEAB approved BS 1362 fuse 
of the same rating must be used. Do 
not forget to refit the fuse cover. In the 
event of losing the fuse cover the plug 
must not be used until a replacement 
fuse cover has been fitted. 
Colour of the replacement fuse cover 
must be the same colour as that 
visible on the pin face of the plug. Fuse 
covers are available from any good 
electrical store.

Important! Fitting A Different Plug

As the colours of the wires in the 
mains lead of this appliance may 
not correspond with the coloured 
markings identifying the terminals in 
your plug proceed as follows: (See 
diagram).

1. 

Connect the green-yellow or green 
(Earth) wire to the terminal in the plug 
marked ‘E’ or with the symbol   or 
coloured green and yellow or green.

2. 

Connect the blue (Neutral) wire to 
the terminal in the plug marked ‘N’ or 
coloured black.

3. 

Connect the brown (Live) wire to the 
terminal in the plug marked ‘L’ or 
coloured red.

With alternative plugs a 13 A fuse must 
be fitted either in the plug or adaptor 
or in the main fuse box. If in doubt 
contact a qualified electrician.