Beko Bcti36510, User Manual

11 / EN

Induction Hob / User Manual

3 

Installation

C

The serial plate is located under 

the cooktop. When ordering parts 

for or making inquiries about your 

cooktop, always be sure to include 

the model and serial numbers and a 

lot number or letter from the serial 

plate on your cooktop.

•

Ensure that there is a distance of 2” between 

the hob and the wall or sides.

•

Ideally the hob should be installed with plenty 

of space on either side. There may be a wall at 

the rear and tall units or a wall at one side. On 

the other side, however, no unit or divider must 

stand higher than the hob.

•

The piece of furniture or the support in which 

the hob is to be fitted, as well as the edges of 

furniture, the laminate coatings and the glue 

used to fix them, must be able to resist temper-

atures of up to 212 °F.

•

The mural rods of edge must be heat-resisting.

•

Not to install the hob to the top of a not venti-

lated oven or a dishwasher.

•

To guarantee under the bottom of the hob cas-

ing a space of 1” to ensure a good air circulation 

of the electronic device.

•

If a drawer is placed under the work, avoid to put 

into this drawer flammable objects (for example: 

sprays) or not heat-resistant objects.

•

Materials which are often used to make work-

tops expand on contact with water. To protect 

the cut out edge, apply a coat of varnish or 

special sealant. Particular care must be given 

to applying the adhesive joint supplied with the 

hob to prevent any leakage into the supporting 

furniture. This gasket guaranties a correct seal 

when used in conjunction with smooth work top 

surfaces.

•

The safety gap between the hob and the cooker 

hood placed above must respect the indications 

of the hood manufacturer. In case of absence of 

instructions respect a distance minimum of 29 

15/16”. 

•

The connection cord should be subjected, after 

building, with no mechanical constraint, such for 

example of the fact of the drawer.

3.4 Electrical connection

•

The installation of this appliance and the con-

nection to the electrical network should be 

entrusted only to an electrician perfectly to the 

fact of the normative regulations and which re-

spects them scrupulously.

•

The electrical parts should always be protected 

after the installation. 

•

The appliance should be connected using a 

multipolar circuit breaker. 

•

If the appliance is not fitted with an accessible 

plug, disconnecting means must be incorpo-

rated in the fixed installation, in accordance with 

the installation regulations. 

•

The inlet hose must be positioned so that it does 

not touch any of the hot parts of the cooktop or 

oven. 

B

Caution!

 This appliance must only 

be connected to a network 220-

240 V~ 50/60 Hz. Always connect 

the ground wire