38/EN
Setting the Rinse aid Amount
1. Press the On/Off key and P2 program
key simultaneously for 3 seconds and
enter the Settings menu after turning
your machine on with On/Off key,
depending on the model you may enter
the Settings Menu by pressing the P3
key for 3 seconds.
2. Move to “P” position on the screen by
pressing the P2 key.
3. Set to a proper level by selecting one
of the “P:0”,“P:1”,“P:2”,“P:3” or “P:4”
positions with the P3 program key.
4. To save, exit the settings menu by
pressing on/off key of your machine for
3 seconds. Your settings shall be saved
automatically.
Applies no rinse aid in P:0 position
during washing program.
Applies 1 dose of rinse aid in P:1 position.
Applies 2 dose of rinse aid in P:2 position.
Applies 3 dose of rinse aid in P:3 position.
Applies 4 dose of rinse aid in P:4 position.
indicator. As long as the error continues,
the washing program is stopped and it is
checked whether the water flows or not
into the machine at certain intervals, when
water flows in, the E:02 icon turns off after
a certain period of time and the washing
cycle resumes.
Water overflow warning
If too much water flows into the machine or
if there is a leak in any part, the machine
will detect an overflow and the E:01
icon will flash on the Program indicator.
As long as the overflow continues, the
safety algorithm will operate and try to
discharge the water in the machine. If the
overflowing stops and the safety procedure
is completed, the E:01 icon will turn off. If
the E:01 icon does not turn off, the error is
permanent and you should call the service.
InnerClean
(depends on model)
This programme is recommended to be
operated on each 1-2 months for machine
cleaning and necessary hygiene. The
programme should be operated while the
machine is empty.
In order to achieve an efficient result, it is
recommended to use together with special
machine cleaning agents.
Do not use this programme to
clean dishes. As it operates in high
temperatures, it is harmful for the
dishes.
End of programme
For energy saving, the machine is
automatically turned off following the
completion of the programme or if the
programme is not started.
Leave your dishes in the machine for
about 15 minutes to allow them cool
down after they are washed. Your
dishes will dry in a shorter time if you
leave the door of your machine ajar
during this period. This process will
increase the drying effectiveness of
your machine.
Water supply is cut-off warning
If the mains water supply is cut off or the
machine water inlet tab is not opened,
water would not flow into the machine and
the E:02 icon will flash on the program