10
EN
4
Preparation
• Your refrigerator should be installed at
least 30 cm away from heat sources
such as hobs, ovens, central heater
and stoves and at least 5 cm away
from electrical ovens and should not
be located under direct sunlight.
• The ambient temperature of the room
where you install your refrigerator
should at least be 10°C. Operating
your refrigerator under cooler
conditions is not recommended with
regard to its efficiency.
• Please make sure that the interior of
your refrigerator is cleaned thoroughly.
• If two refrigerator are to be installed
side by side, there should be at least 2
cm distance between them.
• When you operate your refrigerator for
the first time, please observe the
following instructions during the initial
six hours.
• The door should not be opened
frequently.
• It must be operated empty without
any food in it.
• Do not unplug your refrigerator.
If a power failure occurs out of your
control, please see the warnings in
the “Recommended solutions for the
problems” section.
• Original packaging and foam materials
should be kept for future
transportations or moving.
• Food contact with the temperature
sensor in the freezer may increase
energy consumption of the appliance.
Thus any contact with the sensor(s)
must be avoided.
Summary of Contents for BFNA247E30SN
