Beko BK 2600, User Manual

20

Install indoor unit 

150 m

m

150 m

m

Install the rear panel 

1.Always mount the rear panel horizontally. Due to the water tray of indoor unit has been adopted the

both-way drainage design, the outlet of water tray should be adjusted slightly down when installing, that is 

taking the outlet of the water tray as the center of a circle, the included angle between the evaporator and 

level should be 0 or more, that is good for condensing water drainage. 

2.Fix the rear panel on the wall with screws.
(Where is pre-covered with plastic granula) 

3.Be sure that the rear panel has been fixed
firmly enough to withstand the weight of an 
adult of 60kg, further more, the weight should 
be evenly shared by each screw.

Install the piping hole 

0DNHWKHSLSLQJKROHɎLQWKHZDOODWDVOLJKW

downward slant to the

   outdoor side.

2.Insert the piping-hole sleeve into the hole to prevent the connection piping
   and wiring from being damaged when passing through the hole. 

Install the water drainage pipe 

1.For well draining, the drain hose should be placed at a downward slant. 

2.Do not wrench or bend the drain hose or flood its end by water.

3.When the long drainage hose passing through indoor,
   should wrap the insulation materials. 

Wrenched

Bent

Flooded

Indoor

Outdoor

Wall pipe 

Seal pad 

Fig.5

Wall

Wall

Mark on the middle of it 

Gradienter

Left

Right

(Rear piping hole) 

(Rear piping hole) 

Space
to the
wall

above

Space
to the
wall

above

Connect indoor and outdoor electric wires 

1.Open the surface panel.
2.Remove the wiring cover Fig 6.

3.Route the power connection cord from the back of the indoor unit and pull it toward the front
   through the wiring hole for connection.

4.Reassemble the clampand wiring cover.

5.Recover the surface panel.

Fig.6

N(1) 2

3

yellow-
green

ĭPP

ĭPP

ĭ

blue black brown