Instructions for use
GB
2
Electrical requirements
Before inserting the plug into the wall socket
make sure that the voltage and the
frequency shown in the rating plate inside the
appliance corresponds to your
electricity supply. We recommend that this
appliance be connected to the mains supply
via a suitably switched and fused socket in a
readily accessible position.
Warning! This appliance must be
earthed.
Repairs to electrical equipment should only be
performed by a qualified technician. Incorrect
repairs carried out by an unqualified person
are carry risks that may have critical
consequences for the user of the appliance.
Transportation
instructions
1.
The appliance should be transported only
in a upright position. The packing as supplied
must be intact during transportation.
2.
If during the course of transport the appliance,
has been positioned horizontally, it must not
be operated for at least 4 hours, to allow the
system tosettle.
3.
Failure to comply with the above instructions
could result in damage to the appliance, for
which the manufacturer will not be held liable.
4.
The appliance must be protected against
rain, moisture and other atmospheric influences.
Important!
•
Care must be taken while cleaning/carrying
the appliance not to touch
the bottom of the condenser metal wires at the
back of the appliance, as this
could cause injury to fingers and hands.
•
Do not attempt to sit or stand on top of your
appliance as it is not designed for such use.
You could injure yourself or damage the
appliance.
•
Make sure that the mains cable is not caught
under the appliance during and
after moving, as this could damage the cable.
•
Do not allow children to play with the
appliance or tamper with the controls.
Installation instructions
1.
Do not keep your appliance in a room where
the temperature is likely to fall below 10 degrees
C (50 degrees F) at night and/or especially in
winter, as it is designed to operate in ambient
temperatures b10 and +32 degrees
C (50 and 90 degrees F). At lower temperatures
the appliance may not operate, resulting in a
reduction in the storage life of the food.
2.
Do not place the appliance near cookers
or radiators or in direct sunlight, as this will
cause extra strain on the appliance's functions.
If installed next to a source of heat or freezer,
maintain the following minimum side clearances:
From Cookers 30 mm
From Radiators 300 mm
From Freezers 25 mm
3.
Make sure that sufficient room is provided
around the appliance to ensure free air
circulation.
4.
The appliance should be positioned on a
smooth surface.
5.
Refer to "Cleaning and Care" section to
prepare your appliance for use.
Summary of Contents for BK 7681
