Beko CDA 540, Installation, Operation & Food Storage Instructions

ELECTRICAL REQUIREMENTS 

Before you insert the plug into the wall socket make sure that the voltage and the 
frequency shown in the rating plate inside the appliance corresponds to your electricity 
supply. 
Rating label is on the left hand side of fridge inner liner. 
We recommend that this appliance is connected to the mains supply via a suitable 
switched and fused socket in a readily accessible position. 
Should the mains lead of the appliance become damaged or should it need replacing 
at any time, it must be replaced by a special purpose made mains lead which can only 
be obtained from a BEKO Authorised Service Agent. 
 

WARNING! THIS APPLIANCE MUST BE EARTHED 

If the fitted moulded plug is not suitable for your socket, then the plug should be cut off 
and an appropriate plug fitted. Destroy the old plug which is cut off as a plug with 
bared cord could cause a shock hazard if inserted into a socket elsewhere in the 
house. 
The moulded plug on this appliance incorporates a 13 A fuse. Should the fuse need to 
be replaced an ASTA approved BS 1362 fuse of the same rating must be used. Do not 
forget to refit the fuse cover. In the event of losing the fuse cover the plug must not be 
used until a replacement fuse cover has been fitted. Colour of the replacement fuse 
cover must be the same colour as that visible on the pin face of the plug. Fuse covers 
are available from any good electrical store. 
 

IMPORTANT! FITTING A DIFFERENT PLUG 

As the colours of the wires in the 
mains lead of this appliance may 
not correspond with the coloured 
markings identifying the terminals 
in your plug proceed as follows: 
(See diagram). 
 
1. Connect the green-yellow or 
green (Earth) wire to the terminal 
in the plug marked 'E' or with 
 
the symbol        or coloured 
 
green and yellow or green. 
 
2. Connect the blue (Neutral) wire 
to the terminal in the plug 
marked 'N' or coloured black. 
3. Connect the brown (Live) wire to 
the terminal in the plug marked 'L' 
or coloured red. 
With alternative plugs a 13 A fuse must be fitted either in the plug or adaptor or 
in the main fuse box. 
If in doubt contact a qualified electrician. 

3