Beko CFP1675W, Instructions Of Use

ELECTRICAL REQUIREMENTS

Before you insert the plug into the wall socket make sure that the voltage and the frequency 
shown in the rating plate inside the appliance corresponds to your electricity supply.
Rating label is on the left hand side of fridge inner liner.
We recommend that this appliance is connected to the mains supply via a suitable switched 
and fused socket in a readily accessible position.
WARNING: When positioning the appliance ensure the supply cord is not trapped or 
damaged.
Should the mains lead of the appliance become damaged or should it need replacing at any 
time, it must be replaced by a special purpose made mains lead which can only be obtained 
from a 

BEKO

 Authorised Service Agent.

WARNING! THIS APPLIANCE MUST BE EARTHED

If the fitted moulded plug is not suitable for your socket, then the plug should be cut off and 
an appropriate plug fitted. Destroy the old plug which is cut off as a plug with bared cord 
could cause a shock hazard if inserted into a socket elsewhere in the house.
The moulded plug on this appliance incorporates a 13 A fuse. Should the fuse need to be 
replaced an ASTA approved BS 1362 fuse of the same rating must be used. Do not forget 
to refit the fuse cover. In the event of losing the fuse cover the plug must not be used until a 
replacement fuse cover has been fitted. Colour of the replacement fuse cover must be the 
same colour as that visible on the pin face of the plug. Fuse covers are available from any 
good electrical store.

WARNING: Do not locate extension sockets or charging transformers/power supplies or 
Lithium-Iron battery operated products adjacent to the compressor as they could overheat.

IMPORTANT! FITTING A DIFFERENT PLUG

As the colours of the wires in the
mains lead of this appliance may
not correspond with the coloured
markings identifying the terminals
in your plug proceed as follows:
(See diagram).

1. Connect the green-yellow or
green (Earth) wire to the terminal
in the plug marked 'E' or with
the symbol 

or coloured

green and yellow or green.

2. Connect the blue (Neutral) wire
to the terminal in the plug
marked 'N' or coloured black.

3. Connect the brown (Live) wire to
the terminal in the plug marked 'L'
or coloured red.
With alternative plugs a 13 A fuse must be fitted either in the plug or adaptor or
in the main fuse box.
If in doubt contact a qualified electrician.

3