GB
Instruction for use
Outside cleaning
•
Clean the outside of the appliance by using
a sponge dipped in warm soapy water then
wipe with a soft dry cloth.
•
The cleaning of the outside of the
refrigerating circuit (compressor, condenser,
connection tubes) will be done by using a soft
brush or the vacuum-cleaner. During this
operation, please take care not to distort the
tubes or pull out the cables.
Do not use scouring powder or abrasive
materials !
•
After finishing the cleaning, put the
accessories back in their places and plug the
appliance in.
Replacing the interior light bulb
Should the light fail, switch off at the socket
outlet and pull out the mains plug.
Then ensure the bulb is screwed securely in
the bulb holder. Replace the plug and switch
on.
If the light still fails, obtain a replacement E14
screw-cap type 15 Watt (Max) bulb from your
local electrical store and then fit it
(Item 10)
.
Carefully dispose of the burnt-out light bulb
immediately.
Trouble-shooting guide
In case your appliance does not work
please check if:
•
There is an electricity breakdown.
•
The plug of the supply cord is not introduced
properly into the socket.
•
The fuse is blown.
The temperatures are not low enough.
•
The doors were not closed properly.
•
The food prevents the doors from closing.
•
The appliance was not located correctly.
•
The appliance is too close from a heat
source.
The inside lighting does not work while the
compressor is running.
•
The lamp is blown. Unplug the appliance
from the mains, take out the lamp and replace
it with a new one.
There is water in the lower side of the
refrigerator compartment.
•
The water drain groove is clogged.
There is water in the lower side of the
refrigerator compartment.
•
The water drain groove is clogged.
Red alarm light comes on
On the display will appear messages like:
E0, E1, E3, E4 or E8 – a service engineer will
need to be called.
Until the remedy of the error by the Service,
you can continue the use the appliance,
without the risk of alteration of the food.
The high temperature alarm for freezer
Is activated after 24 hours from an initial
power-up and if the air temperature for freezer
is bigher than -7
0
C.The high temperature
alarm will be off if the freezer air temperature
will drop below -9
0
C.
If the red led lights for a short time. This can
be caused by the introduction of food into the
freezer compartment or because the door was
left open for a long time.
If the ideas given above have not solved the
problem, call customer service.
The following are not defects
•
The fact that on the rear side of the freezer
compartment is warm. This is done on
purpose, to warn the building of the condense
on the outside of the appliance (due to the
moisture in the kitchen).
•
A difference of up to 2 degrees C (35
degrees F) between the displayed value of the
temperature and eventually the one measured
inside the appliance on a certain moment.
8
Summary of Contents for CHA 33100 - ANNEXE 950
