GB
Instruction for use
5
Operation of the control panel
(Item 5)
The operation and control panel adjusts the
temperature in the freezer, displays the
temperature in the refrigerator and has the
following functions:
1 - Fast freeze button
2 - Freezer temperature display
3 - Orange led – Fast freeze on
4 - Green led – Voltage on (TENSION)
5 - Red led – Alarm
6 - Refrigerator temperature display
7 - Temperature setting button
Acc ous tic signalling
When the door of the refrigerator remains open
more than 1 minute, an intermittent audio alarm is
activated.
If the door of the refrigerator is shut, the audio
alarm stops.
Fan
The fans circulates the cold air in both
compartments. It is connected electrically in
parallel with the motor-compressor. When the
motor-compressor is off, the fan will also be off.
The fan of the refrigerator stops 1 second after the
opening of the door and starts 1 secound after its
closing.
In some cases it is possible that the fan in the
freezer compartment starts with a delay
compared to the motorcompressor.
Lamp
The lamp goes on 1 second after the opening
of the door and remains on until it is closed.
Adjustment of the temperatures in the
refrigerator and in the freezer
The temperatures are adjusted by rotating the
temperature adjustment knob (7) from MIN
towards MAX. On the temperature display the
set value of the fridge temperature (6) will
blink for 5 sec. Then the real value read by
the fridge sensor will be displayed.
On the freezer display will be shown the
corespondent temperature value for the set
value.
The inside temperatures of the refrigerator
and of the freezer are correlated as follows:
Refrigerator
adjusted
temperature
Freezer
corresponding
value
+ 8
- 18
+ 7
- 19
+ 6
- 20
+ 5
- 21
+ 4
- 22
+ 3
- 23
+ 2
- 24
The inside temperatures can vary
according to the conditions of use of the
appliance: location, ambient temperature,
frequence of door opening, degree of
charging with food. The temperature
adjustment will be modified according to
these conditions.
Generally, for an ambient temperature of
25
0
C, at the first operation of the appliance,
the temperature adjustment knob will be fixed
on an average position 4
or 5
.
This position can be subsequently
adjusted towards plus or minus according
to the wish of each user.
During the operation of the appliance,
condense drops or ice appear on the inside
back wall. You do not need to remove these
drops, because the back wall is automatically
defrosted. The water which results leaks in
the special groove and is collected in a tray
placed near the compressor, from where it
evaporates.
