Beko CM 9101 BB, User Manual

EN / 11

4 Installation

Please read the “Safety Instruc-
tions” section first!

Your washing machine automatic-
ally detects the amount of laundry
placed inside when selecting a pro-
gram.
While installing the product, before
the first use, calibration should be
done to ensure that the laundry
amount is detected in the most ac-
curate way.
To do this, select the Drum Clean-
ing* program and cancel the spin
function. Start the program without
laundry. Wait for the program to fin-
ish, which will take about 15
minutes.
*The program name may vary de-
pending on the model. For the ap-
propriate program selection, review
the program descriptions section.

• Please contact the nearest Authorised

Service for the installation of the appli-
ance.

• Make sure that the installation and elec-

trical connections of the product are per-
formed by authorised service agent.
Manufacturer shall not be held respons-
ible for damages caused by operations
performed by unauthorised persons.

• Preparation of the location and electrical,

tap water and waste water installations at
the place of installation is under cus-
tomer's responsibility.

• Make sure that the water inlet and dis-

charge hoses as well as the power cable
are not folded, pinched or crushed while
pushing the product into its place after in-
stallation or cleaning procedures.

• Prior to installation, visually check if the

product has any defects on it. Do not
have the product installed if it is dam-
aged. Damaged products cause risks for
your safety.

4.1 Appropriate Installation Loca-

tion

• Place the product on a hard and level

floor. Do not place it onto a carpet with
high pile or other similar surfaces. Inap-
propriate floor may cause problems of
noise and vibration

• Total weight of the washing machine and

the dryer -with full load- when they are
placed on top of each other reaches to
approx. 180 kilograms. Place the product
on a solid and flat floor that has sufficient
load carrying capacity.

• Do not place the product on the power

cable.

• Do not install the product at places where

temperature may fall below 0 ºC. Freez-
ing might damage your product.

• Leave a minimum space of 1 cm

between the product and the furniture.

• If you will install the product on a surface

with steps, never place it close to the
edge.

• Do not place the product on any platform.
• Do not place heat sources such as

cooker, irons, ovens, heater etc. on the
appliance and do not use them on the
product.

4.2 Assembly of Bottom Panel

Covers

• In order to increase the sound comfort of

the product, attach cover A after remov-
ing the package foam.

Cover A

Tilt the machine back slightly. Rest the tabs
of Cover A against the lower panel. Com-
plete the assembly by rotating the cover.