Beko CNG4601DVPS, User Instructions

ELECTRICAL REQUIREMENTS 

Before you insert the plug into the wall socket make sure that the voltage and the 
frequency shown in the rating plate inside the appliance corresponds to your electricity 
supply. 
Rating label is on the left hand side of fridge inner liner. 
We recommend that this appliance is connected to the mains supply via a suitable 
switched and fused socket in a readily accessible position. 
WARNING: When positioning the appliance ensure the supply cord is not trapped or 
damaged. 
Should the mains lead of the appliance become damaged or should it need replacing at 
any time, it must be replaced by a special purpose made mains lead which can only be 
obtained from a BEKO Authorised Service Agent. 

WARNING! THIS APPLIANCE MUST BE EARTHED 

If the fitted moulded plug is not suitable for your socket, then the plug should be cut off 
and an appropriate plug fitted. Destroy the old plug which is cut off as a plug with bared 
cord could cause a shock hazard if inserted into a socket elsewhere in the house. 
The moulded plug on this appliance incorporates a 13 A fuse. Should the fuse need to 
be replaced an ASTA approved BS 1362 fuse of the same rating must be used. Do not 
forget to refit the fuse cover. In the event of losing the fuse cover the plug must not be 
used until a replacement fuse cover has been fitted. Colour of the replacement fuse 
cover must be the same colour as that visible on the pin face of the plug. Fuse covers 
are available from any good electrical store. 

WARNING:

 Do not locate extension sockets or charging transformers/power supplies or 

Lithium-Iron battery operated products adjacent to the compressor as they could 
overheat. 

IMPORTANT! FITTING A DIFFERENT PLUG 

As the colours of the wires in the mains  
lead of this appliance may not correspond  
with the coloured markings identifying the  
terminals in your plug proceed as follows: 
(See diagram). 

1. Connect the green-yellow or green  
(Earth) wire to the terminal in the plug  
marked 'E' or with the symbol or coloured 
green and yellow or green. 

2. Connect the blue (Neutral) wire to the  
terminal in the plug marked 'N' or coloured  
black. 

3. Connect the brown (Live) wire to the  
terminal in the plug marked 'L' or coloured red. 
With alternative plugs a 13 A fuse must be fitted either in the plug or adaptor or 
in the main fuse box. 
If in doubt contact a qualified electrician. 

WARNING:

 Do not locate extension sockets or charging transformers/power supplies or 

Lithium-Iron battery operated products adjacent to the compressor as they could 
overheat. 

4